| Official Luthiers Forum! http://www-.luthiersforum.com/forum/ |
|
| Heat blanket for Uke http://www-.luthiersforum.com/forum/viewtopic.php?f=10128&t=53379 |
Page 1 of 1 |
| Author: | dscheckman [ Sat Jul 25, 2020 2:36 pm ] |
| Post subject: | Heat blanket for Uke |
Hi, Is there any reason not to use a guitar sized heat blanket and fox style bender for bending Uke sides and bindings? I’ve made a couple of guitars and have the bender, slats and blankets. Seems like it would work fine as long as I build the mold the fit. Thanks for any insight. David Sent from my iPad using Tapatalk |
|
| Author: | bcombs510 [ Sat Jul 25, 2020 8:52 pm ] |
| Post subject: | Heat blanket for Uke |
It could work, but the challenge might be the overall length of the mold may not extend out past the walls of your guitar bender. I purchased the uke sized bender from blues creek, it works well. The walls of the bender are smaller so the mold sticks out each end. Brad Sent from my iPhone using Tapatalk Pro |
|
| Author: | Pmaj7 [ Tue Jul 28, 2020 12:09 pm ] |
| Post subject: | Re: Heat blanket for Uke |
That's what I've done. The mold needs to be taller, not only to clear the bouts but also because since it's on rails, you need to have room for the blanket to bend and come out. Pat |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|